Normally Open Contact Symbol

Some of the most common and widely used symbols are given below 1.

Normally open contact symbol.

There is also a generic symbology for any switch contact using a pair of vertical lines to represent the contact points in a switch. Normally open no contacts allow current when the relay or contactor is energized. This is the switch used to operate a doorbell. This symbol is used to indicate normally close contact.

Like the notc contact this type of contact is normally open when the coil is unpowered de energized and closed by the application of power to the relay coil. Energizing it and switching it on will close the contact causing it to allow current flow. Form c contacts change over or transfer contacts are composed of a normally closed contact pair and a normally open contact pair that are operated by the same device. Normally open is a contact that does not flow current in its normal state.

Next we have the normally open timed open noto contact. The given symbol indicates a normally open contact. The following is a timing diagram of this relay contact s operation. Normally open contacts are designated by the lines not touching while normally closed contacts are designated with a diagonal line bridging between the two lines.

Relays and contactors have two types of contacts each suited for different applications. Also now is a good time to remind you that this is article is talking about the electrical normally open and normally closed symbols which while may look the same as the. These terminals are usually labelled as normally open common and normally closed no c nc. Normally closed nc contacts allow current through when the relay or contactor is not energized.

On off switch spst spst single pole. Usually at about 75 speed of motor. Normally open switch contacts are sometimes referred to in the electrical industry as form a contacts. If we had used a normally closed pushbutton switch instead the behavior would be exactly opposite.

In other words when voltage is applied to the relay contactor terminals this contact closes. There is a common electrical connection between a contact of each pair that results in only three connection terminals. This type of push switch is normally closed on it is open off only when the button is pressed. In a schematic diagram the switch symbol appears to be a toggle switch with a flag hanging below.

Note the following symbols.